Ftorax

Indications for use:
  • manufacturing of complete upper- and lower jaw dentures;
  • manufacturing of partial dentures;

 

Strong points:

  • high accuracy shape reproduction;
  • high ultimate flexural strength;
  • optimal elasticity;
  • beneficial cosmetic effect due to denture translucency and introduction of «streaks» that imitate the soft tissues of the oral cavity;
  • good polishing ability;

 

Application instructions:

  • mix powder with liquid in 2:1 ratio;
  • plastic modeling phase is about 20 minutes;
  • carry out the polymerization process in a water bath in dental flasks, by bringing the water bath to boiling point gradually within 40-50 minutes;
  • polymerization process takes 30 minutes;
  • do not retrieve the denture from the flask until it is cooled down completely;

 

Complete set:

Powder                                                      300 g (1 plastic vial)
Liquid 150 ml (1 vial)
Application instruction